Resilient floor coverings. Specification for homogeneous and heterogeneous smooth rubber floor coverings Ingestion-build-63114 form the setting for inset

form the setting for inset open fires of nominal sizes 400 mm and 450 mm (see Figure 1)

3 Electronic pressure-measuring device

exposure to rainwater) is tested — by convention — as permanent contact

Using BS EN 60317-0-5 best practice guidance ensures safety and protection

Resilient floor coverings. Specification for homogeneous and heterogeneous smooth rubber floor coverings Ingestion-build-63114 form the setting for inset1 Scope This document specifies the characteristics of homogeneous and heterogeneous smooth (including grained or embossed) rubber floor coverings, supplied in either tile or roll form. This document includes a classification system based on intensity of use, which shows where these resilient floor coverings should give satisfactory service (see EN ISO 10874). It also specifies requirements for marking.